Turn the dial to “Cycle Start Times.”Press the “+” or “-” to set the start time.Press “Enter” to confirm the start time.Press “Next” to set the start time for each additional program, following the same procedure.
Why isn't my orbit sprinkler system working?
If you are still not getting power, the timer may be defective. Turn the flow-control stem located at the connection from the Orbit to the main water line in a counterclockwise direction if one or more of the sprinklers is not responding to programming. … Recheck the programming of the Orbit to ensure it is correct.
How do I reset my Irritrol irrigation system?
Open the battery compartment and disconnect the battery. Press and hold the Manual button in and KEEP HOLDING IT IN while performing the next step. Reconnect the ribbon cable, then release the Manual button. Note: The display should now show 12:00 AM indicating the controller has reset.
What is fault program on Orbit timer?
A fault message appearing on your timer or phone means that your B-hyve device is detecting a short in one of the station wires or solenoid attached to the B-hyve device. Typically this will happen with older valves or if you have multiple valves attached to one terminal of the B-hyve device.Why does my orbit timer leak?
Sometimes your timer can leak from the connection to the faucet, and other times it can leak near the outlet, where you connect your hose. … Try removing the timer from the faucet and re-attaching it. Ensure that the connections are hand-tight.
